Here ya go fool
 

started my boat blind today will try to keep posting pics. the pics are bad . bad light in my boat. frame is made out of used top rail. it is supported by string right now till i get some cable that i like. any one else have one like this to give me some ideas please let me know.

Wow. That is looking great

man i personally think thatll do just fine

what do yall recomend for my camo pattern i will mostly be hunting open water and timber

looks great!

Less is better. Just enough to cover you. And break up ANY straight lines. Remember. Nothing in nature is straight or has 90 degree angles

I used the 3D cut blind material from cabelas. Build and used my blind for two years now and holding up fine. With the 3d cuts, you can stick other limbs and grass to break up the top line of the blind. I also have a piece of material I keep loose in the boat that I can cover up the top opening with. Only leave holes open for shooting.

How are you going to anchor that material on the sides to keep the wind from blowing it?

I guess you have room to mount the engine?

I am going to put a piece of heavy gauge wire to wieght it down on the bottom side of material. i seen someone elses done this way he said it worked good. also this is just my base i am going to put somemore on top.
the motor will fit the anchor point for the blind is on the seat and when the boat is in motion blind will be folded down.

h2o i was thinking of that for the top. did you use the stuff from cabela's for that

http://www.cabelas.com/cabelas/en/te...=cat601993&rid=

is this the material you used

Thats what I used. Once you put in on, if you see that its to dark or light for your surroundings, you can take some spray paint to lighten or darken the appearance.