4 wheeler electrical question
A few months back, a damn rat got in my 4 wheeler and chewed up some of my wires. I repaired and replaced everything I could find that was damaged and got the last part in today and got it put together. Turned on the ignition and no power. I expected that since the battery had been off for quite a while. Hooked up some jumper cables and she fired right up! Problem is, when I disconnect the jumper cables it dies out. I let it run hooked up to the cables for about 30 minutes but same thing. Any suggestions?
|
EFI?
Had the same problem the battery was shorted out. |
30 minutes with the jumper cables connect may not be nearly long enough for a "dead" battery.
Put the battery on a charger for a few hours and see it the battery can "recover" from being dead for a long time. The battery might charge up ok..... but may not hold the charge. Might need a new battery. |
Quote:
|
Quote:
|
Quote:
Yes, you for sure need a new battery. |
All times are GMT -5. The time now is 08:51 AM. |
Powered by vBulletin®
Copyright ©2000 - [ARG:3 UNDEFINED], Jelsoft Enterprises Ltd.
vB.Sponsors
All content, images, designs, and logos are Copyright © 2009-2012,
Salty Cajun, LLC
No unathorized use is permitted