Extension Handle for 25hp
 

Anyone every make their own extension handle and did it hold up well.

Ive seen crabbers use pvc set up. Looking for some thoughts and plans.

South Side Welding on Common made one from aluminum for me to put on a 25 Yamaha and it turned out well

I have one lying around if you want to borrow it to see how it works. It is pvc and was on my 25. I will be around the house all week until tuesday recovering from an ATV accident. call me at 263-3006 if you wanna come borrow it

thx

I can't believe you didn't ask me first. My feelings are hurt. I had one that I ran for a couple of years when I had a 40 on a 14 x 42. It would porpoise unless I sat farther up. I took a piece of 1 1/2" pvc pipe, made 1-2 cuts about 2-3" inches down the pipe - started with the pipe vertical and cut down not across, slipped it over the handle and used 2 soft stainless clamps to tighten around the handle and put a cap on the end. I think I even put some tennis racket soft wrap on it. Worked great.

lol to "THE" CLIFF CLAVEN of the world

Joe at south side will hook u up

Trolling motor extension

He ain't paying - he is too cheap.

I am still getting royalties from Cheers using my part in that show.
:rotfl:

Tolling motor extension.