Cutting hole in bench seat
Looking for advice or ideas. Would cutting a 10x16 or 18 inch access hole in front or back side of a bench seat cause any structural problems? I'd like to cut a hole to allow more storage. Would I have to reinforce the cutout or would it be good as is.
|
I would reinforce it just to be sure but thats just my opinion
|
Leave a few inches on top and cut to one side not in the middle it should be fine
|
Let Hoe at Southside do it. He usually adds structure inside seat to insure integrity of seat.
D |
Thanks guys
|
Marshrunner. Clear out ur inbox... it wont let me send u a message.
|
Inbox clear. Sorry about that
|
I second the Joe at south side. He's fast and does quality work. He rebuilt the nose on my boat and it was done the day after I dropped it off. Looks like factory
|
All times are GMT -5. The time now is 11:11 PM. |
Powered by vBulletin®
Copyright ©2000 - [ARG:3 UNDEFINED], Jelsoft Enterprises Ltd.
vB.Sponsors
All content, images, designs, and logos are Copyright © 2009-2012,
Salty Cajun, LLC
No unathorized use is permitted