Quote:
Originally Posted by booyagasha
how bad is the rust....is it all over?? or just spot rust? for thick spot rust, you can beat the **** out of it via hammer. For quicker spot rust removal, i would suggest needle gun. i think this would be a better idea, and less expensive than a sandblast pot, sand, and compressor to run it. but if you still need to sandblast....any offshore tool rental company shouldn't be a problem ..dont forget the hood, hood line, and a/c unit
|
It's really just surface rust. I was thinkin about blasting with soda or pecan shells jsut to clean it up. It's not pitted, so a needle gun and heavy blasting is not needed. Just want to spruce it up. Got a good deal on trade. Ole boy wanted my 6 1/2 x 12 single axle and even swapped a 6.5 x 18 dual axle pipe. Just needs a face lift and new boards.