Quote:
Originally Posted by jmarine
the spline on the driveshaft goes straight in the crankshaft on mercs most of the time you have to bump the engine over in order for the splines to meet up one person push lower unit up while the other cranks and also make shure you pull the lanyard out while doing this
|
or shift the lower unit into gear and just turn the prop until it slips in (much easier and sure to line up correctly)
Quote:
Originally Posted by Broken Gun
I got a 98' 150 mercury (salt edition), i dropped the lower unit to change water pump, all went well. Went to stab it back in and the bearing or sleeve that the drive shaft has to go through in order to spline with the crank has come loose and is covering the hole. Tried to center it but does not stay in place. Any suggestions?
|
if you are talking about something in the midsection out of alignment its not supposed to be so find the cause and fix it or it will rub and wear on the shaft. in the short term put the lower unit in position best as you can and lower the motor to the down position then center the collar and gravity wont make it fall to the side so you can put the lower unit back on.