Assuming this is a metal pit blind.
Get you some hog panel, smaller squares than stock panel, easy to weave or tie brush to.
Cut it 24-30 inches wide, depending on the width of the blind, and 2 feet long sections. 8 foot blind would have 4, and 10 foot would have 5. So only the panels that need to be opened, depending on the amount of hunters, open, and when it's slow you don't have to open the whole blind.
Make you some u brackets that the panel can fit into loose, and use self tapping screws to secure to blind right below top rim. Then just bend the panel to the desired angle.
You do a set for the back and the front, and when you bend them, you can make them overlap.
Light weight, easy to open and close, and will last the life of the blind.
|