Here's a before and after:
And here is the end of two weeks of Hard Work!
We are going to go with 4 layers of 1708 on the bottom and 3 on the sides. That's kind of thin, but on the inside we are going to use alot of bulkheads all in corecell, and then the corecell floor, and I think with all the tie-in's we'll end up with 5/6 layers on the bottom and then the floor will help support the hull. We are going with a cummins 210B series engine in the center, so we need to make her light if we want a 20+ knot cruise at 5.5 GPH.
The idea is to make a boat that doesn't burn fuel and gets out to the fishing grounds cheap but fast, and the hope is to offer $600-650 full day offshore trips with food drinks included for up to 5 people.
