And then that brings me up to date, and this is where I am now. Today is the day my box of 24 sheets of corecell was supposed to come in, but not to my surprise, it's not here yet. I shipped it from Florida about 2 months ago, and it should be here anyday. So we are kind of stuck with nothing to do, the next thing on the list are the bulkheads, and the birdcages are ready to go, we just need the foam
SO, to try to get ahead a bit, we decided to do the worst job imaginable! My big friend Harold, and another guy in the shop, went ahead and sanded the whole inside of the hull with 36 grit sandpaper on the 4.5 grinder. That way we can just stick in the bulkheads and glass them to the floor quickly and everything will be sanded and ready to go. So today, i took the day OFF! and the guys spent 10 hours with grinders in hand making fine white powder!!!! The hull cleaned up well though, these will probably be the last photos for a while, when my foam gets out of storage we'll have these bulkheads in quick though!
This photo is deceptive, the motor stringers actually run 65 percent of the hull length, here they look short and small ??? It was the wide angle on the camera, but even with that in mind, you can kind of see where we ended up.
Sorry for the million posts, I kept telling myself I was going to start the thread and then i was worn out. I'll try to keep it up to date from here on out!