Easily the most tedious job of building my new Quepos Fishing Boat, we put the first part of the cap frames on the side of the boat today. I cut them all out yesterday which was a job, but putting them on and lining them up was quite a task today.
Here's a shot mid day. We put the stick across side to side to line up the angles. They were pre cut before i glassed them, but we still had to adjust them a bit.
Then here was when i finally finished them:
And a front view
and then we glassed them in:
We left the next piece on the table drying for tomorrow to install, we might get the cap on tomorrow, we'll see?