Mostly we have been sanding and resanding and resanding. So that doesn't make for very good pictures. But, in addtion to sanding ALOT, we have done a little building. Harold installed some tuna tubes:
They aren't done yet, but that are where they go, and they are stuck on there!
Then we put the rim around where the motor box goes.
And we built the motor breather where we are going to expel the motor box air. This is very unorthodox, but i piped the air back there to get it next to the tailpipe so it's easier not to get downwind of fumes.
And then we put in the speaker boxes. One on each side. Going with 6.5 fusion speakers. I put them under so they don't get wet and so you don't see them as much.
And then here's the ice chest with the hatches installed
And a quick inside shot
Like I said, nothing super exciting, but these are the details that take TIME. Tomorrow we are adding four more guys to sand, we lost two last week, so we need some new ones! I want to get through this fairing stage quickly, but it's a big boat with lots of sanding needed..