View Single Post
  #9  
Old 09-21-2015, 12:09 AM
B-Stealth B-Stealth is offline
Red Snapper
 
Join Date: May 2009
Location: Lake Charles
Posts: 1,382
Cash: 1,461
Default

Quote:
Originally Posted by biggun View Post
U want to angle your 2X6 to where when u drive them the ends will be lower than where U want to bolt them...

Once u have your blind at the height U want lay your boards on the 6" flat. drive your boards. When U get to the end pull up on the board.. To put board under tension...

That when U bolt it to blind. Driving your boards in an X pattern...

If U contact me I can tell U how.. Anchors are Only needed on your sides.. Not front or back.

BTW.. 24" top opening is a little small.. I'd go with about 26-28' top opening.. IMO 24'' doesn't allow u to turn around easily..
Now I Gotchya

Your correct 26-28" would be ideal but this blind was free and is being repurposed. We have a couple other larger comfortable blinds, but the one I'm sinking will be a "take your aggression out on mottled ducks and mallards in the second split blind."

I will call you after I finish the frame, thanks again.
Reply With Quote