jig n spin
drilled small hole in back of head with small bit. Use a drill press please. On one end of swivel I close the loop with pliers so I don't have to drill a big hole. I need to get my solder iron back from a buddy to see if I can melt the end back closed to hold the swivel. I have used the little wire forms that they make but wanted it short for flounder. There are a few made like this but the are pricey like $ 1.50+ each. The redfish one at academy is a little long for what I like. The jig-wire-spin on left side is a Owner Flashy swimmer 2 for about $6.00. I bought most of these parts from Barlows Tackle. I use 65 lb braid and a medium rod and set the hook hard to make sure I get good penetration. I need to make up about a hundred and I will be set for flounder fishing.
|