Quote:
Originally Posted by Gerald
Anyone have a good suggestion on how best to clean out inside the tube to get the rust out?
Is there some kind of small wire brush or sanding disk to attach to a drill that will fit "Just right" to clean it out good.
I under stand that there is a special nut with grease zert that can be installed on the other end of the stearing rod. I went to West Marine but they did not have them. I never went to a boat dealer.
|
http://www.overtons.com/modperl/prod...ID=1006&r=view
To clean the tube I use a wire brush bit on a cordless drill with plenty of pb blaster.