View Single Post
  #1  
Old 10-03-2017, 09:17 PM
bjhooper82's Avatar
bjhooper82 bjhooper82 is offline
Sailfish
 
Join Date: May 2011
Location: Lafayette
Posts: 4,910
Cash: 3,813
Default 4 wheeler electrical question

A few months back, a damn rat got in my 4 wheeler and chewed up some of my wires. I repaired and replaced everything I could find that was damaged and got the last part in today and got it put together. Turned on the ignition and no power. I expected that since the battery had been off for quite a while. Hooked up some jumper cables and she fired right up! Problem is, when I disconnect the jumper cables it dies out. I let it run hooked up to the cables for about 30 minutes but same thing. Any suggestions?
Reply With Quote