thanks
for all the help..
I think I have it figured out ( I'll have to post a few pictures)
I sheared up some 10ga 10" and bent it in the pressbrake at 3" to make
it look like an angle iron. I cut a 4x4 x1/8" thick.
cut it at a 25 deg. angle and welded to the 7" part of the 10 ga. that I had bent.
so the bottom of the legs are about 10' apart on a 8' tall 4x4.
came out kewl a/f!!!
also the 5x5 box blind on the top is made out of some drop aluminum
I had laying around..
I'm going to spray foam the inside too
I'll put some pictures when I get some time
|