SaltyCajun.com http://www.acadianamarina.com//
MESSAGE BOARD Register Weather/Tides/Launches Store Go Premium! Sponsors Raffles Mark Forums Read

Notices

Go Back   SaltyCajun.com > General Discussion Forums > General Discussion (Everything Else)
Reload this Page Weed Eater Help

General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here.

Reply
Page 1 of 2 1 2
 
Thread Tools Display Modes
  #1  
Old 02-14-2012, 10:41 PM
oldwelder oldwelder is offline
Flounder
  
Join Date: Aug 2011
Location: sulphur ,la
Posts: 99
Cash: 803
Default Weed Eater Help
Weed eater quit running , bought a new carb installed it and it ran fine. However after about an hour of use it quit again . It will only idle if chocked and will not rev up. I also changed the suction hose and filter. It is an echo brand bought on 05.

Part B if it is shot Sthil or Echo for replacement ?
Reply With Quote
  #2  
Old 02-14-2012, 10:43 PM
southern151's Avatar
southern151 southern151 is offline
Blue Marlin
  
Join Date: May 2009
Location: Gonzales
Posts: 8,705
Cash: 3,546
Default
If a hammer won't fix it, its an electrical problem.
Reply With Quote
  #3  
Old 02-14-2012, 10:45 PM
PaulMyers's Avatar
PaulMyers PaulMyers is offline
Super Moderator
  
Join Date: Aug 2010
Location: Moss Bluff, LA
Posts: 10,057
Cash: 18,565
Default
Sound like the throttle linkage needs to be adjusted/set.

I have both Stihl and Echo. I prefer the Echo because it does not flood as easily.

HTH

+1
Reply With Quote
  #4  
Old 02-14-2012, 10:52 PM
wtretrievers's Avatar
wtretrievers wtretrievers is offline
Ling
  
Join Date: May 2009
Location: Central
Posts: 3,690
Cash: 2,527
Default
If it'll run on choke & dies when fuel is added you still have a fuel problem. Sounds like trash in carb. Those carbs are so small it doesn't take much to screw em up.

I had a Stihl for 7 years, bought a Shindiawa & that thing is a beast!!!!

Also check the primer bulb, they'll get old crack & suck air.
Reply With Quote
  #5  
Old 02-14-2012, 11:22 PM
jldsc's Avatar
jldsc jldsc is offline
Red Snapper
  
Join Date: May 2010
Location: Evangeline, LA
Posts: 1,375
Cash: 2,749
Default
HUSKAVAURNA....I have a husky trimmer and chainsaw for the past couple of years with 0 issues...My mom and dad have had so much trouble with there stihl (4 carbs) under warranty that they went to husky...my 2 cents if looking for a replacement.
Reply With Quote
  #6  
Old 02-15-2012, 12:11 AM
jchief's Avatar
jchief jchief is offline
Calcasieu Extreme Rods
  
Join Date: May 2009
Location: Carlyss, America
Posts: 10,371
Cash: 13,395
Default
When i first saw this, i figured you was having issues with the Andrus clan. Echo
Reply With Quote
  #7  
Old 02-15-2012, 12:15 AM
PaulMyers's Avatar
PaulMyers PaulMyers is offline
Super Moderator
  
Join Date: Aug 2010
Location: Moss Bluff, LA
Posts: 10,057
Cash: 18,565
Default
Quote:
Originally Posted by jchief View Post
When i first saw this, i figured you was having issues with the Andrus clan.
I did the same thing. :thumbup:

+1
Reply With Quote
  #8  
Old 02-15-2012, 03:32 AM
1fastmerc's Avatar
1fastmerc 1fastmerc is offline
Sailfish
  
Join Date: Mar 2011
Location: Moss Bluff
Posts: 4,680
Cash: 1,505
Default
Quote:
Originally Posted by jchief View Post
When i first saw this, i figured you was having issues with the Andrus clan. Echo
I was wondering what that dummy had gone off and done now. Lol


Sent from my iPhone using Tapatalk
Reply With Quote
  #9  
Old 02-15-2012, 05:50 AM
weedeater's Avatar
weedeater weedeater is offline
Sailfish
  
Join Date: Mar 2011
Location: Moss Bluff, La
Posts: 5,057
Cash: 2,464
Default
Quote:
Originally Posted by 1fastmerc View Post
I was wondering what that dummy had gone off and done now. Lol


Sent from my iPhone using Tapatalk
I ain't done nuttin......
I am having similar issue with my blower which I have pulled carb apart and cleaned but it didn't help, I belive my issue is from putting ethonal gas in mine along with 8 yrs of heavy use. I run all Echo and have had good luck to this point except for this issue and that's with me cutting a lot of grass and abusing my equipment for 8 yrs along with having others use my equipment when working for me.
Reply With Quote
  #10  
Old 02-15-2012, 06:31 AM
oldwelder oldwelder is offline
Flounder
  
Join Date: Aug 2011
Location: sulphur ,la
Posts: 99
Cash: 803
Default
Quote:
Originally Posted by jchief View Post
When i first saw this, i figured you was having issues with the Andrus clan. Echo
No I don't know weedeater or 1fastmerc but they seem like fun guys that don't mind gigging each other.
Reply With Quote
  #11  
Old 02-15-2012, 06:36 AM
Hydro's Avatar
Hydro Hydro is offline
King Mackeral
  
Join Date: Jan 2011
Location: Lake Charles
Posts: 2,123
Cash: 5,054
Default
Is your exhaust plugged up ??? Fairly common to end up with a chunk of carbon hung up around the exhaust port on the muffler... You should be able to pull the spark arrestor out and see what's going on...
Reply With Quote
  #12  
Old 02-15-2012, 07:10 AM
jdm4x43732's Avatar
jdm4x43732 jdm4x43732 is offline
Red Snapper
  
Join Date: Aug 2011
Location: Crowley, Louisiana
Posts: 1,881
Cash: 3,142
Default
Quote:
Originally Posted by jldsc View Post
HUSKAVAURNA....I have a husky trimmer and chainsaw for the past couple of years with 0 issues...My mom and dad have had so much trouble with there stihl (4 carbs) under warranty that they went to husky...my 2 cents if looking for a replacement.
X2 I have a Husquvarna weed eater and that thing is an animal.
Reply With Quote
  #13  
Old 02-15-2012, 07:12 AM
oldwelder oldwelder is offline
Flounder
  
Join Date: Aug 2011
Location: sulphur ,la
Posts: 99
Cash: 803
Headknocker
Quote:
Originally Posted by Hydro View Post
Is your exhaust plugged up ??? Fairly common to end up with a chunk of carbon hung up around the exhaust port on the muffler... You should be able to pull the spark arrestor out and see what's going on...
I took the muffler off and cleaned the screen , should be good on that end.
Tried it again this morning it will only idle on choke. Almost ready to try the hammer method !!!
Reply With Quote
  #14  
Old 02-15-2012, 07:17 AM
swamp snorkler's Avatar
swamp snorkler swamp snorkler is offline
Swordfish
  
Join Date: May 2009
Location: Raceland
Posts: 6,731
Cash: 3,477
Default
If I use a weed eater for 5 years thats a win for me. If you do replace it buy from your local dealer. When I bought my ECHO 2 years ago the dealership gave me a 5 year warranty on everything!!!!! So I paid right under $200 for a weed eater thats going to last me at least 5 years. I also bought a toro push mower from them and it came with a 5 year warranty on everything and a 10 year warranty on anything the oil touches.
I bought all my stuff at The Power Shop on St. Charles ST in Houma.
Reply With Quote
  #15  
Old 02-15-2012, 07:41 AM
inchspinner's Avatar
inchspinner inchspinner is offline
Ling
  
Join Date: Dec 2010
Location: Moss Bluff
Posts: 3,732
Cash: 8,577
Default
check prime bubble and gas lines for cracks....get an echo.
Reply With Quote
  #16  
Old 02-15-2012, 08:23 AM
jldsc's Avatar
jldsc jldsc is offline
Red Snapper
  
Join Date: May 2010
Location: Evangeline, LA
Posts: 1,375
Cash: 2,749
Default
idle air mixture adjustment maybe??? have you tried adjusting the idle needle
Reply With Quote
  #17  
Old 02-15-2012, 08:28 AM
ragincajun's Avatar
ragincajun ragincajun is offline
Flounder
  
Join Date: Aug 2009
Location: Lafayette
Posts: 90
Cash: 1,189
Default
Take a look at a Shindaiwa my Dad has had the same one since I was old enough to pick that thing up and I'm 31. I bought one a couple years ago for myself and I started it for the first time in 3 months the other day and it started with 2 cranks. That thing has some power, its expensive but well worth the money.
Reply With Quote
  #19  
Old 02-15-2012, 10:08 AM
weedeater's Avatar
weedeater weedeater is offline
Sailfish
  
Join Date: Mar 2011
Location: Moss Bluff, La
Posts: 5,057
Cash: 2,464
Default
I won't knock any brand but remeber the warranty is only as good as the abilty to have it serviced, best bet is go to a shop that deals with a good brand and will do the service and repairs.
Reply With Quote
  #20  
Old 02-15-2012, 01:00 PM
Pat Babaz's Avatar
Pat Babaz Pat Babaz is offline
Trophy Trout
  
Join Date: Feb 2011
Location: Sulphur, La
Posts: 475
Cash: 1,213
Default
I would clean the carbarater again. If you put the new carb on and ran it with the old fuel line and filter they probably gunked up your new carb. Ethanol gas is some bad stuff.
Reply With Quote
Reply
Page 1 of 2 1 2

Bookmarks

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 04:49 PM.


Contact Us - Louisiana's Best Fishing, Hunting, and Outdoors Forum - New Posts - Mobile - Archive - Privacy - Terms - Top

Powered by vBulletin®
Copyright ©2000 - [ARG:3 UNDEFINED], Jelsoft Enterprises Ltd.
vB.Sponsors
vBCredits v1.4 Copyright ©2007 - 2008, PixelFX Studios
SaltyCajun.com logo provided by Bryce Risher

All content, images, designs, and logos are Copyright © 2009-2012,
Salty Cajun, LLC
No unathorized use is permitted
Geo Visitors Map