Quote:
Originally Posted by BIGJ
It dont miss a lick when running wot only when idleing and will kill.
There are small bubbles coming from the leak. Is this water or gas in this area?
|
its fuel and oil mix coming from this area, there is no gasket on this section of the motor just a type of putty like a hondabond or yamabond.
1 1/2 turns out on the screw will be a good starting point also check the timing base plate you may have to bump up the idle timing just a little to get it to run at idle..also double check your your points gap I believe on this motor its right around .018 to .020, chances are is the timing is a little to low at idle, make sure you dont mess with the WOT timing just idle timing you can easily melt a hole in the pistons..