View Single Post
  #11  
Old 06-05-2011, 08:36 PM
Shawn Braquet's Avatar
Shawn Braquet Shawn Braquet is offline
Ling
 
Join Date: Aug 2009
Location: Lake Charles
Posts: 3,241
Cash: 4,901
Default

Quote:
Originally Posted by LPfishnTIM View Post
if the gas wasn't on there would be more little holes in the weld! so it looks like it was! I use to work in a shop inspecting welds on scaffold before it got galvanized, all welds had to be 3/4 of an inch long on all points to be approved safe. as long as your weight isn't too much your welds should be good.
This going to be a row builder for gardening, the plates allow me to slide my discs wider and narrower and adjust the angle. What im gettin at is that it'll have apush against it but the dirt will already have been broken up by the time i use this.
Reply With Quote