I just completed this one as a "cultipacker" for my food plots. I am not completely satisfied with the design and I am bag to paper on some changes. I may end up welding flate plate to it and onverting it to a ATV buffalo. I have a 2" collar welded on one side to allow for ballast. Either water or sand.
The roller section is 48" and outside to outside of frame is 53" to accomadate my ATV trailer. The tounge slides out to flip over since I will be putting some wheels on it to run from plot to plot. The total in it so far is $165, but the pipe was a defective piece from a job.
|