[biggun]

Hi Guys.. I'm wanting to get a Atlas Hydraulic Jack-Plate.

This is for my 24' Triton LTS... 250 Yama 4 stroke.


A few friends have motors with 6'' offsets. Is this enough?? Should I look into a 8", 10" ??? I think I know a few of the pros. Are there ANY CONS to them???

Will I have to RE-PROP my engine after I get this installed????

I want it MORE to get it up when I'm in the reefs.. I hope to get Trim my bow up a little more when TRIMMED UP....I know I may get a little better gas mileage and speed..

Again I Mainly want it for the Reefs..

Any help would be appreciated...

PLease respond to Gunner AKA Biggun, on here , a private message, or text or email..

337-781-9581

Thanks

Biggun