Just unplug the wires for the sensor. Its only an alarm. There's a vacuum like that has to be plugged and on the pump itself, just run a tube between the inlet and outlet ports. When u pull the pump, you should be able to grad the drive shaft with needle nose pliers and give it a few jerks to pop it out. Mine on the other hand wouldn't pop out. Had to remove carbs and intake and reed plate and get to it from inside. Just a couple good taps with screwdriver and hammer from the back and it popped right out. Almost forgot. I removed the reservoir completely and will fiberglass the hole in cowling and have it repainted.
Sent from my SAMSUNG-SGH-I727 using Tapatalk 2
|