I've been getting my film from TWN industries, It can be a pain without the right set up, which I don't have. Would love to get the right set up but you're looking at a good chunk of money
Several things that are critical are water temp, amount of activator applied, too much or to little on the activator can screw things up! Along with water temp & clean water. I did a ton of test runs before I ever touched a gun! I did elec outlet covers to small plastic tool cases just about anything that paint would stick to & didn't have any value I dipped or should I say tried to dip till I got the hang of it.
This will be the next camo I get, I have an old Marlin 30-30 that this would be badazz on!
http://www.watertransferprinting.com...0Camo-Bonz.jpg