[keakar]

POWERTECH SS PROPELLER THAT WAS REHUBBED A FEW WEEKS AGO TO FIT NISSAN/TOHATSU 40/50HP MOTOR (but I bought a speed prop instead)

THE TOHATSU HUB WILL ALSO FIT YAMAHA AND MERCURY MIDSIZED MOTORS USING YOUR ORIGINAL THRUST WASHERS AND HARDWARE

WILL ALSO MATCH SUZUKI AND EVINRUDE 13 SPLINE SHAFT BUT MAY REQUIRE ADDITIONAL WASHERS UNDER PRPOP NUT FOR PROPER KEYWAY SPACING

WILL FIT ANY MID SIZED MOTOR OF ANY BRAND IF YOU REHUB IT (average cost to rehub a prop is $50)

THIS PROP WAS USED ON A TOHATSU MFS40HP MOTOR AND WAS A PERFECT FIT FOR SIZE AND PITCH ON THOSE MFS40/50HP MOTORS.

PROPELLER IS 11.25 DIAMETER AND 13* PITCH 13 SPLINE SHAFT

HAS VERY MINOR SPOTTING OF RUST THAT CAN EASILY BE BUFFED AND POLISHED OUT IF THAT MATTERS TO YOU

PROPELLER HAS NEVER MADE CONTACT WITH ANY HARD OBJECTS AND ONLY SHOWS MINOR BLEMISHES FROM NORMAL USE

ASKING PRICE IS $100