Quote:
Originally Posted by Gerald
Thanks for the pic.
I see that this must be mounted to hole that is in the bracket. If I can find a piece thick rubber, I could make something like you have.
I will have to closely observe the head to see if it is still vibrates while running in choppy water.
|
For the cost of a 3.5"x 1/4" galv. bolt [~$2.] I came up with this.
I cut off a small piece of the tubing shown in the picture and attached it to the 1/4" bolt on the bottom side of the TM bracket.
The parts I ordered last week to rebuild the motor, finally shipped out yesterday.
.