Quote:
Originally Posted by B-Stealth
; I think it adjust the engine timing or something but it "feels" stronger.
|
Some cars use a device that can
advance the valve timing. This does not keep the valves open longer; instead, it opens them later and closes them later. This is done by rotating the camshaft ahead a few degrees. If the intake valves normally open at 10 degrees before top dead center (TDC) and close at 190 degrees after TDC, the total duration is 200 degrees. The opening and closing times can be shifted using a mechanism that rotates the cam ahead a little as it spins. So the valve might open at 10 degrees after TDC and close at 210 degrees after TDC. Closing the valve 20 degrees later is good, but it would be better to be able to increase the duration that the intake valve is open
Several engine manufacturers are experimenting with systems that would allow infinite variability in valve timing. For example, imagine that each valve had a solenoid on it that could open and close the valve using computer control rather than relying on a camshaft. With this type of system, you would get maximum engine performance at every RPM. Something to look forward to in the future...
The Tundra uses a Double Overhead Cams (DOHC), a 32-valve head design and Dual Independent Variable Valve Timing.
Overhead camshaft (OHC) valvetrain configurations place the camshaft within the cylinder heads, above the combustion chambers, and drive the valves or lifters directly instead of using pushrods. When compared directly with pushrod (or OHV) systems with the same number of valves, the reciprocating components of the OHC system are fewer and in total will have less mass. Though the structures that support the system may become more complex, most engine manufacturers easily accept the added complexity in trade for better engine performance and greater design flexibility. The OHC system can be driven using the same methods as an OHV system, these methods may include using a timing belt, chain, or in less common cases, gears.
Many OHC engines today employ Variable Valve Timing and multiple valves to improve efficiency and power. OHC also inherently allows for greater engine speeds over comparable cam-in-block designs.
Quote:
Originally Posted by B-Stealth
Well I admit the fuel efficiency is better when I set the computer to kilometers.
|
