With the hull straight, we decided to put the motor mounts / mini stringers. I didn't want to put in some super big stringers because we are going to put in alot of corecell bulkheads, but I wanted something to help the hull out where the motor was going to be mounted. We built the non wood parts by just making a one layer of 1708 on the table and cutting it into 6 inch strips and using some bondo (with extra activator to dry fast) to make boxes attached to the floor. Then we got out the filet knife and made a nice 1 inch filet with Cabosil (which was grey, some offbrand I'm sure?) and then used that as a mold to put on 4 layers of 1708. We still have to put some holes in it so that it doesn't hold water (at the bottom so water will flow to the bilge if any goes down there). Not the prettiest, but it'll work, and it'll give the hull a little more thickness where the motor goes. We are still going to clean this up and close the end, but I figured I'd take some pictures of the process.
I shot this right before we hid this beautiful wood. This is some amazing Iron Wood we are using to mount the motor. This is a purple version of CocoBolo called Nazereno. It's bright purple and has the best grain swirls, like most things that are really cool, the picture doesn't do it justice. We chose it because it is one of the hardest woods here and it doesn't rot. That is where we are going to bolt on the stainless part of the motor support table, I'd explain it, but pretty soon I'll just post pictures of it finished and that will be easier!
