Still waiting on the corecell to get in, but I managed to find enough scraps to make the border around the edge where the floor will sit. This is also what i'm going to use to make my birdcages which we start next. The boat is going to live on a mooring, so I made the floor a hair higher than I would have if it was going in the marina so that water doesn't come in through the back scuppers at night when there are waves, and then I also put quite a bit of fall from the front to the back so that if a bunch of people go up front, I won't have a little pond up there.
We also roughly put the floor to the bathroom in. Still have to clean that up, but I found a 1 inch divinycell that a friend had so we glassed it and stuck it where the bathroom floor will be.
And then with a little time on our hands and now knowing where the floor goes, we put the tube in the muffler that will go out the back and we are going to finish the muffler next. The floor will sit on the top of the muffler and it will be the same height as the bulkheads on top.
