Well, we got some of the floor down. The two strips of floor by the motor we had stuck down yesterday with cabosil and then today we glassed the edges. We did a 12 inch strip on those, 6 on the floor and 6 on the wall to hold the pieces down. And then we sanded it off flush to wrap another 12 incher into the motor compartment and the bathroom to tie everything together nicely.
The front had a weird angle on it, I don't know that we did that on purpose, but we are going to build a wrap around bench up there, so you won't see the front of the floor anyways, up by the nose. But because of the angle we couldn't build that on the table, we had to glass just the bottom on the table, and then glass the top in place, and then I put another 10 inch strip around the edge for a little more strength. Got a nice resin burn on the face from that one, lots of vapor, but we got it done.
And then for some reason, we didn't make the little piece of floot that connects the sides to the front, so we are put those on the table to glass in tomorrow.
I think tomorrow we are going to cut the foam for the console also, maybe start glassing those pieces so we can get the console in place in a day or two. It's starting to look more like a boat!