Didn't get as much done as I wanted, but we did get the basic idea of the under bench rod holders in place, we'll finish that out tomorrow and then I'll post some pics. The idea is the front piece will have four holes in it to put 4 rods in, and then the back two holders will have two holes in each side. And 4 per side will be 8 rods. After we took this picture we got everything glassed up.
And then this is the motor box on the table. The first view is side view of the motor box and then the second picture is the rest of the box on the table.
Hopefully we'll get the rod holders figured out tomorrow and the bench installed, and maybe the box put together...we'll see