Got a little done today. We started by hole sawing the front rod holder that will be under the seat. I'm going to buy Harold a ruler, one of the holes got away from him, but it's under the bench, so we decided to leave it.
After we got the holes made in the rod holder, we put the bench where it goes and then marked and cut down the center to get it at the right height. This kind of shows how light it is, this already is all glassed up except for the top, and the little guy carries it like it's nothing.
And then we got it where it went and put the cabosil in the seam:
And then we glassed it in. I haven't done the ends yet because I'm not sure how I'm going to do them yet. We are trying to just knock out the bulk of the big construction and then go back and hit the details. That's why we have this crazy pace, but finishing everything up is going to be at least a months worth of fairing
On a different note, the seat looks HUGE because the border isn't on the boat yet. Once we put the border on the boat the seat will be more normal sized.
And then we decided to put the motor box together.
But, after putting it together, realized it was going to be a little too wide and there wasn't enough area to pass by on the side, so we stopped that and we're going to make it about 4 inches narrower tomorrow and we finished up the front bench. More pics tomorrow if we get something finished!