![]() |
![]() |
![]() |
|
General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
I need a device that I can use with my Dremel to cut stencil patterns out of 5 mil Mylar sheeting. I was looking at a 1/32" End Mill. Are any of you guys familiar with these bits? I read where they're designed to cut plastics. This will be some intricate cutting, so, I need something that is very small and will also make smooth cuts. This is the smallest size I could find. I don't need a tutorial on the bit....I just need to know if you think it will work for my application.
Oh, btw...thanks. ![]() Here's a pic.... |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|