Can I use the cheap tcw3 marine oil

[datcajunman]

Can I use the cheap tcw3 marine oil in my Mercury engine? Until now I have only used the Quicksilver 2 cycle oil for $30 a gallon. I am open for suggestions for something cheaper.

[Raymond]

Tcw3 meets all mfr recommendations. Using the spensive oil only makes u poorer and name brands richer,IMO.

[datcajunman]

Any advise on a particular name brand

[weedeater]

my grandpa has been runnin walmart brand over 5 yrs and burns hundreds of gallons of gas a yr and so far so good, its a merc 40

[LPfishnTIM]

I've always used the pennzoil premium twc3 2stroke oil, its 18.99 a gallon, but I thought there was a gallon of quiksilver for 20.99 it just isn't synthetic, does it matter if its synthetic oil when its going to burn with gas anyway? those are my questions?

[booyagasha]

as much as an outboard cost, i would not use nothing but recommended oil. my evinrude uses xd-50 and i hear e-techs use xd-100(fully synthetic) i know for those motors, there's a setting to switch from xd-100 to twc3

[TDaigle]

When you look at price per gallon per gallon of fuel you are talking a few cents. I have had several mechanics tell me to run Yamalube when I had a 2 stroke Yamaha. It was never worth it to me to be cheap on something that can leave u dead in the water.

[LaAngler]

some maybe not ALL of the cheaper stuff leaves more residue behind than the premium oil

there is a difference

[Dink]

I use Pennzoil premium plus......recommended by my mechanic after rebuild

[LPfishnTIM]

Originally Posted by Dink

I use Pennzoil premium plus......recommended by my mechanic after rebuild

I think thats what I've been using but its still cheaper than a lot of other brands, I haven't had any problems but I got an older motor and its probably better stuff then the oil they had when the motor was made.

[weedeater]

i was told by a mech that he only runs o.p. oil in his motor and he runs a hopped up 250 merc on a bullet. i am runnin a 25 yammy and i was askin him about the oil i run which is amsoil and he said it was really good stuff if you want to spend the money which he then told me again about his o.p. oil, so i finally ask him about this o.p. oil to be told that it stands for other peoples oil. he told me when he removes oil systems from outboards he just keeps the oil out of the tank if people dont want it and mixes it in his gas.

[LPfishnTIM]

Originally Posted by jasonandrus

i was told by a mech that he only runs o.p. oil in his motor and he runs a hopped up 250 merc on a bullet. i am runnin a 25 yammy and i was askin him about the oil i run which is amsoil and he said it was really good stuff if you want to spend the money which he then told me again about his o.p. oil, so i finally ask him about this o.p. oil to be told that it stands for other peoples oil. he told me when he removes oil systems from outboards he just keeps the oil out of the tank if people dont want it and mixes it in his gas.

probably runs O.P. gas too, your boat ever have less gas then when you brought it that would explain!

[weedeater]

Originally Posted by LPfishnTIM

probably runs O.P. gas too, your boat ever have less gas then when you brought it that would explain!

no but if he could have gotten gas out of my empty tank he could have it

[booyagasha]

i think as long as you don't have a special ram injected/direct injected 2 stroke , the older 2 strokes won't have a problem.Try it on a newer higher technology stroke....like a FICHT or a ETEC or HPDI......no way