|
Boating Talk For discussion of everything related to boats and motors |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Lake Area Marine?
|
#2
|
||||
|
||||
I think 5:30. Ask Paul Meyers. His daughter works there.
Sent from my iPhone using Tapatalk |
#3
|
||||
|
||||
5 pm weekdays, noon Saturdays.
|
#4
|
||||
|
||||
I heard you were grounded, anything serious ??? Hydro |
#5
|
||||
|
||||
I was close. :-)
Sent from my iPhone using Tapatalk |
#6
|
||||
|
||||
I have no idea how bad? Motor ran like a champ from the orange boat ramp to I-10 then died. I got it started but when I would put it in gear and give it some gas it would die. I went last night and bought a new tank,hose,and fittings. The fitting that I bought for the tank was for an evinrude,but the hose won't snap and stay on the fitting. I used my old tank today and when I got home I noticed some cracks around the area around the base of the fitting on the tank?Im thinking of just making it an anchor!!!!!!!!!!!!!
|
#7
|
||||
|
||||
Fuel, fire, and rotation... Gotta have em', you know the drill
I presume you fished your way back to the landing an limited out ... Hydro |
#8
|
||||
|
||||
I didn't even have a pole in the boat. I went just to run the boat. I thought it was good until it died. My little e-tec went to e-junk! Its still under warranty so I'm putting in the shop.
|
#9
|
|||
|
|||
I bet it is your fuel pump, I know of 2 25hp E-Tec motors that had this problem
|
#10
|
||||
|
||||
Do you have a fuel filter/water separator on your motor.
Sent from my iPhone using Tapatalk |
#11
|
||||
|
||||
Quote:
Thanks for all the info! |
#12
|
||||
|
||||
Quote:
Sent from my iPhone using Tapatalk |
#13
|
||||
|
||||
I had the same problem with my 25 merc, the problem was the fuel line inside the tank was cracked and sucking air, not getting fuel from the tank. Put a new line in tank no more problems.
|
#14
|
||||
|
||||
I was thinking about that,yesterday I pull the line out of the tank and the fuel stayed in the tube. When I would tap on the tube the fuel would drain out back into the tank???
|
#15
|
||||
|
||||
It could be getting air in line and losing suction.
|
#16
|
||||
|
||||
Well looks like its to the shop we go! I came home today it started up first pull and idled fine. I looked at the engine management module and one of the LED lights is on for sensor fault. I sure hope its a speedy recovery!
Thanks for all the help and ideas. |
#17
|
||||
|
||||
Quote:
Good luck !!! Better get that thing runnin' quick, its pre-fish time Hydro |
#18
|
||||
|
||||
Im going to bring it to shop very soon. We only have three weeks to get ready!
|
#19
|
||||
|
||||
Good luck latex!!!!
|
#20
|
||||
|
||||
Looks like its going to be FIVE WEEKS until lake area marine can get to it.
|
Bookmarks |
|
|