![]() |
![]() |
![]() |
|
General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]() ImageUploadedByTapatalk1374352023.047288.jpg ImageUploadedByTapatalk1374352033.249418.jpg |
#2
|
|||
|
|||
![]()
I got 4 old rims....but different bolt pattern....sorry.
Maybe you can buy some tubes and put inside the tires. If the hubs are very old, might be good idea to check the grease in the wheel bearings before pulling the tailer. Also, if the tire rubber looks to be very dry-rotted......you might be better off replacing the tires. You might find some Use/junk tires for cheap. |
#3
|
||||
|
||||
![]()
We put some "new" used tires on them for now. I think we are going to try your idea that a buddy had also mentioned to use the tubes. We only need to go 30 miles. If we go slow the tubes should hold. We are going to also sand down the rust real good before putting the tubes and tires back on. The Huns spin pretty good but I'll try to grease them before the trip too. Hopefully this works!
|
#4
|
||||
|
||||
![]()
Acadiana rim repair in lafayette. Jude will hook you up!
|
![]() |
Bookmarks |
|
|