4 wheeler electrical question

[bjhooper82]

A few months back, a damn rat got in my 4 wheeler and chewed up some of my wires. I repaired and replaced everything I could find that was damaged and got the last part in today and got it put together. Turned on the ignition and no power. I expected that since the battery had been off for quite a while. Hooked up some jumper cables and she fired right up! Problem is, when I disconnect the jumper cables it dies out. I let it run hooked up to the cables for about 30 minutes but same thing. Any suggestions?

[Andy C]

EFI?
Had the same problem the battery was shorted out.

[Gerald]

30 minutes with the jumper cables connect may not be nearly long enough for a "dead" battery.


Put the battery on a charger for a few hours and see it the battery can "recover" from being dead for a long time. The battery might charge up ok..... but may not hold the charge. Might need a new battery.

[bjhooper82]

Originally Posted by Gerald

30 minutes with the jumper cables connect may not be nearly long enough for a "dead" battery.


Put the battery on a charger for a few hours and see it the battery can "recover" from being dead for a long time. The battery might charge up ok..... but may not hold the charge. Might need a new battery.

I'm thinking I may need a new battery regardless. I bought the 4 wheeler brand new in 08 and it's still the original battery on it. Thanks for the advice, I'll try that tomorrow.

[Feesherman]

Originally Posted by bjhooper82

I'm thinking I may need a new battery regardless. I bought the 4 wheeler brand new in 08 and it's still the original battery on it. Thanks for the advice, I'll try that tomorrow.

Yes, you for sure need a new battery.

[bjhooper82]

Originally Posted by Andy C

EFI?
Had the same problem the battery was shorted out.

Yes, it's EFI