rpm range

[adamsfence]

just got my jackplate put on my suzuki 90. I was running around 5600 rpms now with out triming out about 5900. Is this ok. I haven't heard a rev limiter. just want to make sure im not overreving

[adamsfence]

4 stroke and was just me i went to prien to test it after i got it

[adamsfence]

its manuel......i just found the info on my motor it says 5800-6300 so i should be fine i guess

[adamsfence]

i went up 4 inches didn't want to go to high i may raise it up....its just hard because im so far from water to trailer back and forth alot.

[jchief]

If you need some help and you come down, let me or us know and I will be glad to help. I live in Carlyss

[Gerald]

I can help if you want to put in the Calcasieu river off hwy 171 in Moss Bluff. Or maybe in Westlake.

I live a few minutes away and can go almost any time.

[adamsfence]

thanks guys i might take yall up on that later....im gonna try it with a full load and see how it runs and what my rpms run