|
|
|
|
|||||||
| General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
08-31-2011, 09:00 PM
|
||||
|
||||
lookinf for someone to build a gill bracket
ASAP !!!does anyone know a good aluminum welder and fabricator ,around the abbeville area, i need a gill brack built for my aluminum boat at a reasonable price , bubba leblanc in erath closed shop, and deharts shipyard are to busy,, looking to start on it soon !!, i have a 25 inch transom and about to buy a 20 in shaft motor ,so i need a gill braket, any help is appreciated. or looking to buy a late model 25 inch shaft mercury 150 or yamaha 150 with controls,something that saves on fuel.. thanks
Last edited by kbaudoin; 08-31-2011 at 09:45 PM. 
|
|
#2
09-01-2011, 10:41 AM
|
||||
|
||||
|
Give these guys a call
|
|
#3
09-01-2011, 11:04 AM
|
||||
|
||||
|
Give Sterlings Upholstery & Fab in New Iberia
(337) 364-1859 (337) 364-0783
|
|
#5
09-01-2011, 01:50 PM
|
||||
|
||||
|
i know you said abbeville but Kurt Venable in rayne is very good. He builds crawfish boats and all kinds of other stuff. Not sure what his number is but his business is Venables Fabrications.
|
|
#6
09-01-2011, 03:30 PM
|
||||
|
||||
|
gill bracket
thanks guys , the guy in erath told me he charged 3-4 hundred, but he sold his shop this week , sterling in new iberia wanted 1800-2000 dollars, i will try some of the other ones , thanks again
|
|
| Bookmarks |
|
|
Hybrid Mode
