Fish Finder In Front Of Bay Boat

[Fishaholic247]

Originally Posted by jl8200

Fish I'm curious how you ran the TM wiring to the unit. Do you have any pictures of that?

Pic #1 Notice how I ran the power wire down into the RAM base under the deck. I will install a few stick on clips to tighten up the wire going to TM.

Pic#2 I picked this bracket up online.

Pic#3 Coil your extra cable and neatly zip tie it inside your TM bracket

Pic #4 On most Tm mounts there is a channel between the shaft and the mount. Remove the door bracket, lift up your shaft and stick you wire in there. Once you tighten it down it stays loose. and notice the little loop if you will...leave slack in cable for turning so you don't pull cable and put it in a bind.

I am no professional but I am a WEB research freak and this is how it was done.