vertical water spray from motor

[Top Dawg]

Originally Posted by CajunChristian

The rig needs to be properly set up. By that, the motor needs to run about 3 degrees positive trim at WOT with your normal load. That can be accomplished several ways. Once the rig is set up to run the proper trim angle, then start raising the engine till it blows out, then drop it 1/2".
D

^^^listen to this man.

[weedeater]

Originally Posted by Top Dawg

^^^listen to this man.

I will agree with this but I will also say that speed wise you probably close to max because that's a heavy boat with small motor but if it gets to the fishing hole it works. if you need prop work go to or ship it to Coastal Prop in Bridge City, TX or you can use Prop Shop in Lafayette but don't use anyone in ake Charles unless cajunchristian tells you a place, it sounds like motor is to low and you just need a jackplate.