Prop advice

[jchief]

What would make a tunnel pull hard to one side? Prop is fairly new and it has been worked on

[Raymond]

Originally Posted by jchief

What would make a tunnel pull hard to one side? Prop is fairly new and it has been worked on

Tab not set properly, too much prop out of the water wide open. Mines pulls a bit at top end even with tab turned all the way to the opposite side but not unmanageble. You'll loose it if the tab ever comes off (don't ask).

Any advantage of running a clever prop on a tunnel hull rig??

[ml2oo3]

Originally Posted by Raymond

Tab not set properly, too much prop out of the water wide open. Mines pulls a bit at top end even with tab turned all the way to the opposite side but not unmanageble. You'll loose it if the tab ever comes off (don't ask).

Any advantage of running a clever prop on a tunnel hull rig??

Semi cleaver props have alot better bite at higher trim settings than a round ear blade all I run on tunnel boats. Four blade semi cleavers work very well on tunnels also.