Lowrance HDS help

[C-Bass2mouth]

Originally Posted by wishin i was fishin

Network, actually doesn't have anything to do with it. If your bow unit works at both locations, and your console unit works on neither, then the problem is in the console unit.

If you can not successfully do a hard reset on the console unit, then it will have to go to the factory unfortunately.

you will need to bump up the fuse on your console/lss1 power lead to at least 6 amps, 10 amps max.

Here are the reset directions just in case.

Thanks,

I tried the soft reset with no luck. Didn't want to do the hard reset just yet until I had no other choice. I'll try that today after work.

I thought about doubling the fuse size to 6 like you're saying too. I fished Saturday with just the bow unit at the console and played around with the structure/side scan and it worked fine with a 3 amp fuse. I just would rather blow a few fuses than burn a unit up not knowing if the 6 amp was ok to do. But you're saying it's good to go with a 6 amp correct?