Tips and Tricks

[C-Bass2mouth]

Originally Posted by Paulox86

Soak it with a good penetrating oil and keep soaking it and it will come out. Get a good choke wrench and it will come out. Also try some heat and the barrel will expand a bit to let the choke loose. Once it's out, use a good choke tube grease and it will never cease again.

Thanks for the tip. I know he said he soaked it for a day or so in oil, not sure what kind. And the only choke wrench I know him to have is a quarter lol.

[duckman1911]

Originally Posted by C-Bass2mouth

Thanks for the tip. I know he said he soaked it for a day or so in oil, not sure what kind. And the only choke wrench I know him to have is a quarter lol.

Lock that quarter in some vise grips for extra leverage. I keep anti sieze on the threads of all my tubes. Not had an issue yet.

[dave]

Never flip a quarter to see who has to pick up on the boat trailer when it's been backed off the end of a launch. Especially at Lake Martin when the water is 45 degrees...

[kibb]

Originally Posted by dave

Never flip a quarter to see who has to pick up on the boat trailer when it's been backed off the end of a launch. Especially at Lake Martin when the water is 45 degrees...

Run the winch strap and/or rope under the last crossmember of the trailer then hook it the bow of your boat. Reverse the boat and the trailer should come up. Let someone else pull the truck up while you are lifting the trailer.

[duckman1911]

Originally Posted by dave

Never flip a quarter to see who has to pick up on the boat trailer when it's been backed off the end of a launch. Especially at Lake Martin when the water is 45 degrees...

And that my friends is why I dont gamble. You can loose.
45 degree water can cause some crawfishing in certain areas.

[1fastmerc]

Originally Posted by duckman1911

And that my friends is why I dont gamble. You can loose.
45 degree water can cause some crawfishing in certain areas.

Lol

Sent from my SAMSUNG-SGH-I317 using Tapatalk

[Bdv2642]

Blue Brillo pad will take the rust off of most metal (gun barrels, knives, etc...) without damaging the metal. Never tried it on a blued barrel though.

[RickLafayette]

Originally Posted by Bdv2642

Blue Brillo pad will take the rust off of most metal (gun barrels, knives, etc...) without damaging the metal. Never tried it on a blued barrel though.

A copper penny will also remove rust from bluing w/o damaging the bluing.

[Andy C]

When gater hunting bring a ball peen hammer. They will and do come alive in the boat!!!

[Ragin_Cajun]

Hook the trailer with your anchor and pull away. Nobody gets wet!

[jpeff31787]

Originally Posted by Ragin_Cajun

Hook the trailer with your anchor and pull away. Nobody gets wet!

what is this for? Back up too far down the ramp or something?

[PotLikinisAhabbit]

If you have a leak in one of your boots you can use a trash bag over that foot to get you through the hunt. It will keep your leg/foot dry but you will still be pretty cold.

[C-Bass2mouth]

Felt or burlap used as a base layer wrapped around your blind (not a pit blind obviously) will help out with the wind chill.

[tboy]

You can make any pair of boots or waders "ankle tights" with an old tire tube. Cut about a 2 inch wide strip out of the tube. Slip the whole thing over your foot and around your ankle, criss-cross it once then loop the remaining tube over your foot again.

[kibb]

Yes