Edge boats

[AARON5082]

Originally Posted by riverrunner28

did he deliver it to you? if so, that is jam up.

Tim delivered my boat back personally and made sure i was satisfied with the repair. He really is an awesome guy.

[PaulMyers]

Originally Posted by AARON5082

Got my boat back this morning. Tim did an excellent job on the repairs. Got to spend a few minutes with him before he had to leave. He really is a great guy. He even went over some other welds that werent to pretty and made sure every one was done correctly. I must say it was a great job on the repair. He talked about a new boat model that he should be finished with next week. Its a 15 1/2 x 53. He said he is putting a very hot merc on it (80hp) and expects speeds in the 60's. It may be something to look at if anyone is in the market for a new hull.

Danny, is Tim putting one of your motors on the new boat?

[AARON5082]

Tim has a merc that was built by kent foreman.

[Keywest18]

Do you know what the beam will be on the new boat? What is the beam on your 556?

[CajunChristian]

Originally Posted by thegr8cody

Do you know what the beam will be on the new boat? What is the beam on your 556?

Bout 65".
D

[AARON5082]

40 tohatsu tldi. My hull has a hook in it. The hulls with a straight bottom are a few mph faster. Lake area ran a 1550 with the same motor and it gps 52mph.

[CajunChristian]

Originally Posted by AARON5082

40 tohatsu tldi. My hull has a hook in it. The hulls with a straight bottom are a few mph faster. Lake area ran a 1550 with the same motor and it gps 52mph.

That is flying with a 16' boat.
D