Prop?

[budndawn]

I went from 13p aluminum to 14p stainless same diameter....it should still run that 12p without blowing out...do you have a tach on it

[Clafleur]

1548 alweld semi v

[Clafleur]

No tach, and just had a jack plate installed. A friend said my jack plate is prolly too high but it was doing it before the jack plate

[Top Dawg]

You should be able to run a 14 easy. I'm not too fond of powertech props though.

[Top Dawg]

And it does sound like you're jacked a little high for that prop.

[Marshrat]

Originally Posted by Clafleur

It's a power tech 12p, it's what the guy from power tech recommended when I called

When I was in the market for a prop for my 90 Optimax, the guy at Power Tech told me I needed a 13p because of my boat having a tunnel. I ended up with a 19p with heavy cup and it still wasn't enough. I would bet you could add some pitch or add some cup if it is a tunnel hull and solve your problem.


Warren

[Top Dawg]

I see CajunChristian is viewing. Maybe he will give his expert advise on this topic.

[budndawn]

drop it down an inch and see if it helps...mine is on a 15' alumaweld with a jackplate and i also have a 15p i run with no problem

[CajunChristian]

Drop 1/4" at a time until the cavitation stops. All you guys running 14's, how many rpm's you turning those 14's?
D

[Top Dawg]

Danny you and I set up mine with a 14 Yamaha turning 6000

[boben1968]

Hey guys I am looking for a set of throttle plates ( butterflies ) for a Tohatsu M40D set of carbs. Talked to Danny T. boats.net, called all boats shops. Any ideas? Ypu can e-mail me @ bobby.crochet@lyondellbasell.com with any help. Thanks, Bobby..

[Kyle71]

Clafleur, I would recommend a 13', we have put quite a few of those on this set up and it is running very good.

[Kyle71]

You could probably get away with the 14' but I do not think it will have the same balance of hole shot and speed as the 13'.

[amiller72]

I have the same boat a CLAFLEUR except its a 16/48. Empty with just me i'm running 39, three people loaded down I'm running 33-34. I have a 13p powertech, do yall think I could maintain more top end with a load if I increased pitch? Kyle set me up good, I love my new rig, just curious.