|
DIY Forum This forum is for discussion of Do-It-Yourself projects, including home building and remodeling, automotive repair, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Granite
|
#2
|
||||
|
||||
Quote:
Sent from my iPhone using Tapatalk - now Free |
#3
|
||||
|
||||
Angle grinder with a diamond wheel . Make sure u cut relief cuts so when u get to the end of a long cut the weight of the drop does not cause it to snap into the section you are keeping
|
#4
|
||||
|
||||
A granite router ( a router with a diamond bit) will only work if you have a bit that has a bearing and a template ( guide for the bearing to ride on below) you will not b able to control a router with a straight bit free hand . Angle grinder is your best bet , have someone hold the shop vac close to the wheel because the grit will go into the drawer slides below and cause the bearings to not glide good
|
#5
|
||||
|
||||
Quote:
Sounds like you've done this more than once or really messed up on your 1st attempt. |
#6
|
||||
|
||||
It's the same concept a wood , except when you screw up its costs a hell of a lot more
|
#7
|
|||
|
|||
Thanks for the advice! I sure don't want to mess it up. I wasn't sure if I should try to grind the 1/4" off or try to cut it off.
|
#8
|
||||
|
||||
Don't grind it , use the grinder with a cutting wheel
|
Bookmarks |
|
|