|
Boating Talk For discussion of everything related to boats and motors |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Atlas 6 inch Jack Plate
|
#2
|
||||
|
||||
Have one on my new boat and i like the atlas hydraulic jackplate so far. I've only had it for a couple of weeks though
|
#3
|
||||
|
||||
After owning an Atlas, I just went with the new Bob's Action Jack on my new Yellowfin 24.
http://www.bobsmachine.com/products/...jac_series.cfm I know Atlas has a lot of units on the water, but my Atlas cost me $400 over 15 months of ownership - down twice. 1) gradual leak down issue just sitting on the trailer or running; 2) the other was the ram lacked torque to trim boat over 50 mph. Warranty covered parts only, NOT freight or labor. That was my experience. I know of several guys that will not buy another Atlas. Others will say their Atlas has been flawless. I know this though the new Bob's is quicker, smoother, quieter and stronger. Good luck. |
#4
|
|||
|
|||
Jack plate
Thanks for the information. Didn't know Bob's had come out with this new one. Skeeter, did you order it from Bob's direct? Thanks again. Tom
|
#5
|
||||
|
||||
Jack Plate
Quote:
Ladder - http://www.bobsmachine.com/Products/boardingladder.cfm ACTION JP - http://www.bobsmachine.com/Products/...jac_series.cfm I just told YF to put the Bob's Action JP (10 inch) on my new 24. YF has been a big Atlas shop except for the Yam 350s on the 24, and were VERY impressed with the new Bob's. Then I had two guys on my boat over in Galveston and they commented "night and day" difference with the Bob's over the Atlas. Hope this helps. |
#6
|
|||
|
|||
Boarding ladder
Thanks again, for the info. Skeeter. Found their website. The ladder is a great idea; didn't know it existed!
|
Bookmarks |
|
|