Any suggestion
 

I'm thinking about taking the carpet off the front and back deck of my bay boat and paint it. Any suggestion on what kind of paint to use the fiber glass. Also would like to do the floor too. 17ft fiber glass bay boat.

sent from HTC inspire

rhino-line it...

That's what on the floor of the boat. But its flacking off.

sent from HTC inspire

oh, ok... go to overtons.com.... there is a type flooring thats similar to most bay boats w/o carpet.

i'll get you the link

http://www.overtons.com/modperl/prod...3&merchID=4006


use that with this...


http://www.overtons.com/modperl/prod...ID=1006&r=view

that stuff is awesome

Yeah I want to put some on the front and rear deck on my boat.

When I fished in waterbowls boat in FL he has the whole bottom of his lowtide done in it

I saw pics of his boat,I think it has sea dek. More expensive than hydroturf. http://www.seadek.com/

yeah you right it is sea dek...my bad

Take the carpet off, then haul your boat to Lyle Johnson behind the Northgate Mall on Evergreen St. He is the best fiberglass guy in our area, and does the work for all the major insurance companies. He will shoot your floor after laying some gelcoat on it and it will be more afforadable than you think!!!! Will look a lot better than paint and last forever. Tell him "Foti" sent you, and you won't be disappointed!!

Wanna come look at my boat and still say that?

I used fiberglass specialties in scott several times and he does awesome work. Phone number is 269-0902.

Check out Kiwi Grip

I painted the floor of a fiberglass boat with traffic marking paint. Looked good and was tough as nails.

It should be gelcoated unless you go with hydroturf or similiar material.

you can coat it with a two part epoxy primer(gray) which is as tough as it gets..mix small batches, rolling it on and throw you a little sand in it as you coat it..absolutely the cheapest route, do-it-yourself way that will last as long as the boat will..You can go to a local auto-paint supply an ask for it in PPG.I covered my old kenner with this, it mixes 1-1 which was two usable gallons. Check out my thread "1990 18' kenner".

It was PPG Marine Coatings, Amercoat 137 Epoxy Primer..for an old boat all you need, unless you plannin on restoring it. CHEAP!

Lyle Jordan