|
General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Extension Handle for 25hp
Ive seen crabbers use pvc set up. Looking for some thoughts and plans. |
#2
|
||||
|
||||
South Side Welding on Common made one from aluminum for me to put on a 25 Yamaha and it turned out well
|
#3
|
||||
|
||||
I have one lying around if you want to borrow it to see how it works. It is pvc and was on my 25. I will be around the house all week until tuesday recovering from an ATV accident. call me at 263-3006 if you wanna come borrow it
|
#4
|
|||
|
|||
thx
|
#5
|
|||
|
|||
I can't believe you didn't ask me first. My feelings are hurt. I had one that I ran for a couple of years when I had a 40 on a 14 x 42. It would porpoise unless I sat farther up. I took a piece of 1 1/2" pvc pipe, made 1-2 cuts about 2-3" inches down the pipe - started with the pipe vertical and cut down not across, slipped it over the handle and used 2 soft stainless clamps to tighten around the handle and put a cap on the end. I think I even put some tennis racket soft wrap on it. Worked great.
|
#6
|
|||
|
|||
lol to "THE" CLIFF CLAVEN of the world
|
#7
|
||||
|
||||
Joe at south side will hook u up
|
#8
|
||||
|
||||
Trolling motor extension
|
#9
|
|||
|
|||
He ain't paying - he is too cheap.
|
#10
|
|||
|
|||
I am still getting royalties from Cheers using my part in that show.
|
#11
|
||||
|
||||
Tolling motor extension.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|