|
|
|
|
|||||||
| Boating Talk For discussion of everything related to boats and motors |
 |
|
|
Thread Tools
|
Display Modes
|
|
#1
03-20-2010, 02:21 AM
|
|||
|
|||
Electrical demons...help!
switched them around a minute later and now i have no trim, no ignition.... traced wires from battery to remote couldn't find any fuses or breakers.... any ideas? i hated to tear into the remote if it could be something simple i'm overlooking. 
|
|
#2
03-20-2010, 02:25 AM
|
||||
|
||||
|
Hopefully it is a burnt wire somewhere.
Did you try to jump across the solenoid to see if it will turn over? If you have a meter or light, see if you have voltage at the battery, starter, key switch... ect. All of the major areas. There may also be an fusable link somewhere in the positive wire. It is hard to tell without seeing what you have.
|
|
#4
03-20-2010, 02:31 AM
|
||||
|
||||
|
Should have a relay for up & one for down, but they should only get power to them when the trim button is pushed.
 There has to be a fuse somewhere....more than likely theres a fuse under the cowling. Most of the time its on the right side looking at the back of the motor
|
|
#6
03-20-2010, 02:44 AM
|
||||
|
||||
|
I meant to mention the ignition also......there has to be a fuse somewhere, no way that the ignition & trim are wired direct. Has to be a fuse
I could be wrong, have seen some crazy things!
|
|
#7
03-20-2010, 02:45 AM
|
||||
|
||||
|
if everything quit you have to have a fuse burnt or something........man i hate it for you tracing down wiring is a pay in the a$$. you will just have to get a meter and find out where you loose power. thats the only way if you can't find a fuse
|
|
#8
03-20-2010, 02:54 AM
|
||||
|
||||
|
The only thing in the throttle box is ignition switch, trim & cables (no fuses)& a pain in the @zz to put back together if it's not in there. Is there a panel with all fuses on it? Make sure you check under the cowling for that fuse, had one blow on 60 hp & like to have never figured it out, then I just happened to find it!
|
|
#9
03-20-2010, 02:56 AM
|
||||
|
||||
|
The battery can have 12 vdc and still not have enough amps to carry a big load.
The battery may need to be load tested with a battery tester. Or try another battery. Check and see if any of the lights are working. That isn't a big load, but it might help you troubleshoot where the power is interupted.
|
|
#10
03-20-2010, 03:00 AM
|
|||
|
|||
|
no fuse panel, i'll try looking under the cowling tomorrow, was hard to see anything tonight with a flashlight....
battery has full power, i tested trolling motor on it to make sure..... just ran the thing last sunday, i burnt something when i hooked it up backwards....had to. found this thread, not enough info but sounds the same issue
|
|
#14
03-20-2010, 01:21 PM
|
|||
|
|||
|
Test
Start w/ one wire and check continuity move to next wire and so on. If you have multiple wires that do not show continuity THERE is a fuse block or main breaker blown somewhere.Or a burnt harness.
|
|
#15
03-20-2010, 01:33 PM
|
||||
|
||||
|
Fuse on the motor 4 shur
|
|
#17
03-20-2010, 06:02 PM
|
||||
|
||||
|
Yes
Quote:
|
|
#18
03-20-2010, 07:13 PM
|
||||
|
||||
|
Redchaser is right, I did the same thing once, it's a little fuse on the engine. It's cheap to fix, you just have to find the little booger. I guess it's there to save the power pack. You don't want to ruin one of those. Good luck, let us know what you find.
|
|
#19
03-20-2010, 09:27 PM
|
|||
|
|||
|
Quote:
bingo, 20 amp fuse blew, extra was right next to it  thanks all
|
|
#20
03-20-2010, 09:28 PM
|
||||
|
||||
|
Quote:
when we hittin lacassine ti?
|
|
| Bookmarks |
|
|
Linear Mode
